| Flange diameter | D | 525 | mm |
| Bore diameter | d | 395 | mm |
| Basic static load rating, axial | C0a | 1,580,000 | |
| Limiting speed | nG | 1,600 | |
| Flange diameter lower tolerance | -0.03 | mm |
| Bore diameter lower tolerance | -0.02 | mm | |
| Fatigue load limit, axial | Cua | 34,000 | |
| Basic dynamic load rating, axial | Ca | 241,000 | |
| Height | T | 65 | mm |
| Axial and radial runout, measurement standard; Measured on mounted bearing, with ideal adjacent construction. | t1 | 6 | µm |
| Rib diameter inner ring | d1 | 450 | mm |
| Height contact face outerring H1 lower tolerance | -0.20 | mm | |
| Height contact face outer ring | H1 | 42.50 | mm |
| Outside diameter D3 | D3 | 488 | mm |
| Outside diameter D1 | D1 | 486 | mm |
| Height contact face outerring H1 upper tolerance | 0.20 | mm |
| Quantity of retaining screws | 2 | ||
| Quantity of threaded extraction hole | 3 | ||
| Pitch separation angle | t | 7.50 | ° |
| Quantity of fixing holes outer ring | 45 | ||
| Quantity of fixing holes inner ring | 46 | ||
| Counterbore diameter of fixing holes | d2 | 15 | mm |
| Pitch circle diameter fixing holes in outer ring | J1 | 505 | mm |
| Screw tightening torque | MA | 25.07 | Nm |
| Threaded extraction hole | G | M12 | |
| Pitch quantity | n | 48 | |
| Fixing holes diameter outer ring | d3 | 9.30 | mm |
| Counterbore depth of fixing holes | a | 8.20 | mm |
| Fixing holes diameter inner ring | d1 | 9.30 | mm |
| Pitch circle diameter fixing holes in inner ring | J | 415 | mm |
| Manufacturer | Part Number |
|---|---|
| S4M | SEL/D395 |
