Specifications
Lubrication | Weight |
---|---|
No initial lubrication | 20g |
D | 16 | mm | |
C1 | 16.20 | H13 | |
D1 | 14.70 | mm |
C | 25 | mm | |
C2 | 1.10 |
amax | 100 | m/s² | |
m | 0.02 | kg | |
Breakaway force (One wiper seal: Multiply by a factor of 0.5.) | 1 | N | |
Rows of balls | 4 | ||
Shaft radial clearance h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 18 + 5 |
||
Permissible ambient temperature (min ... max) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
vmax | 2.50 | m/s | |
FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 0.50 | N | |
m (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
Working bore diameter tolerance | + 12 + 2 |
||
Operating conditions | Operating conditions |