| reduced power dc | 8 w | ||
| thermal insulation class of the actuator | h | ||
| coil insulation material (encasement) | epoxy | ||
| protection type ip (max. with suitable connector) | ip65 | ||
| electrical connection position | top | ||
| installation length | 100 mm | ||
| valve setting opening time | yes | ||
| switch time close max. | 4.000 ms | ||
| switch time open max. | 800 ms | ||
| switch function | on/off | ||
| main valve operating principle | diaphragm valve | ||
| operation | servo-controlled | ||
| Type | 5,282 | ||
| main valve orifice 1 (p) (mm) | 20 mm | ||
| qnn value (gas) | 7.000 l/min | ||
| rated power consumption | 8 w | ||
| sealing toward outside material | epdm (ethylene-propylene-diene rubber) | ||
| seat seal material category | elastomer | ||
| temperature medium max | 90 °c | ||
| nominal pressure max (liquid) | 10 bar | ||
| pilot control material medium-contacting | brass | ||
| battery voltage | yes | ||
| voltage tolerance negative | 10 % | ||
| voltage max / rated voltage | 24 v | ||
| port connection 2 thread marking | 3/4 | ||
| port connection 2 type | inner thread | ||
| port connection 1 thread marking | 3/4 | ||
| manual actuation stop | yes | ||
| manual actuation | yes | ||
| valve function number of switching positions | 2 | ||
| Customscode | 84818079 |
| rated power dc | 11 w | ||
| coil wiring overvoltage protection | without | ||
| coil type | block bolted | ||
| electrical connection polarity | irrelevant | ||
| electrical connection number of contacts | 2 + grounding conductor | ||
| valve setting closing time | yes | ||
| nominal operation/duty cycle | 100 % | ||
| switch time close min | 1.000 ms | ||
| switch time open min | 100 ms | ||
| valve construction | valve complete | ||
| media separation | yes | ||
| actuator type | pivot | ||
| main valve orifice 1 (inch) | 3/4 inch | ||
| pilot control orifice (mm) | 2 mm | ||
| kv value (water) | 6,5 m3/h | ||
| pilot control seal material | epdm (ethylene-propylene-diene rubber) | ||
| seat seal material | epdm (ethylene-propylene-diene rubber) | ||
| temperature environment max | 55 °c | ||
| temperature medium min | -25 °c | ||
| nominal pressure min | 0,2 bar | ||
| main valve wetted material | brass | ||
| dc voltage | yes | ||
| voltage tolerance positive | 10 % | ||
| voltage min / rated voltage | 24 v | ||
| port connection 2 thread type | g | ||
| port connection 1 thread type | g | ||
| port connection 1 type | inner thread | ||
| manual actuation type | key button | ||
| Valve function | a - normally closed - inlet port 1 (p/nc) | ||
| fluidic port connection number | 2 |
