a)
Lubricating hole M8 x 1 sealed with plastic cap
| D | 32 | mm | |
| E3 | 76 mm ±0.15 | ||
| E5 | 32 | ||
| H | 25 | mm | |
| H1 | 50 | mm | |
| H4 | 16 | mm | |
| protección de máquina (Clamped (fastened) in relation to Ø d.) | 30 mm ±0.01 | ||
| N3 | 18 | mm | |
| S3 | M8 | ||
| Interruptor | 4 |
| B1 | 60 | mm | |
| E4 | 45 mm ±0.15 | ||
| E6 | 50 | mm | |
| Tolerancia para H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 13 | mm | |
| Línea | 104 | mm | |
| N2 | 24 | mm | |
| S2 (Fixing screws ISO 4762-8.8) | 6,60 | ||
| S4 (Pin hole centering.) | 5 | mm | |
| Válvula | 5 | mm |
| amáx | 150 | m/s² | |
| protección de máquina | 0,72 | kg | |
| Fuerza de arranque | 3 | N | |
| Condiciones de operación | Operating conditions |
| vmáx (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1,50 | N | |
| Juego radial | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Temperatura ambiente permitida (mín ... máx) | -10 °C ... +80 °C |
