| S2 (Holes at center of dimension C) | 3 mm +0.1 | ||
| K1 | 1,50 | mm | |
| C2 | 1,85 | ||
| C | 58 | mm |
| S1 (Holes at center of dimension C) | 3.5 mm +0.1 | ||
| D1 | 38,50 | mm | |
| C1 | 43,70 | H13 | |
| D | 40 | mm |
| Temperatura ambiente permitida (mín ... máx) | -20 °C ... +80 °C | ||
| Holgura radial del eje h6/diámetro interior M7 | + 18 - 14 |
||
| Holgura radial del eje h6/diámetro interior H7 | + 43 + 11 |
||
| protección de máquina (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 3 | N | |
| vmáx | 5 | m/s |
| Condiciones de operación | Operating conditions | ||
| Holgame radial del eje h6/diámetro interior K7 | + 25 - 7 |
||
| Filas de bolas | 7 | ||
| Fuerza de arranque (One wiper seal: Multiply by a factor of 0.5.) | 7 | N | |
| protección de máquina | 0,15 | kg | |
| amáx | 150 | m/s² |
