| D | 32 | mm | |
| C1 | 31,20 | H13 | |
| D1 | 30,50 | mm |
| C | 45 | mm | |
| C2 | 1,60 |
| amáx | 100 | m/s² | |
| protección de máquina | 0,10 | kg | |
| Fuerza de arranque (One wiper seal: Multiply by a factor of 0.5.) | 12 | N | |
| Filas de bolas | 5 | ||
| Holgame radial del eje h6 (Determined from working bore diameter and shaft tolerance statistics. Recommended housing bore tolerance: H6 or H7. ) | + 23 + 6 |
||
| Temperatura ambiente permitida (mín ... máx) (Only unsealed Linear Bushings with steel ball retainers may be used at higher temperatures. Make allowance for reductions in load capacity. ) | -10 °C ... +80 °C |
| vmáx | 2,50 | m/s | |
| FR (One wiper seal: Multiply by a factor of 0.5.,Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| protección de máquina (Friction coefficients of unsealed Linear Bushings when lubricated with oil. The friction coefficient is lowest under heavy load, but can still be above the specified value even under a low load. ) | 0,001 ... 0,004 | ||
| Tolerancia del diámetro del orificio de trabajo | + 14 + 2 |
||
| Condiciones de operación | Operating conditions |
